Error: Could not load file (0x7e) C:\HardDisk\Drv\.DLL on Embedded View

SUMMARY

When working on an embedded Edge viewer, you may encounter a message similar to the following:

“Could not load file (0x7e) C:\HardDisk\Drv\ABCIP.DLL” on embedded view”

This can happen for any driver; it is not specific to ABCIP.DLL.

The first step should be to verify that this file does actually exist in the specified location. If you’ve verified this, but the issue persists, this tech note will provide a resolution to this issue.

APPLIES TO

AVEVA Edge HMI

PROCEDURE

1. Locate the ISSetupPreqrequisite files. They can be found in “Installer_path\DISK1\ISSetupPrerequisites”

2. Copy those folders on the Embedded machine and stop/close AVEVA Edge.

3. Perform the installation procedures in the ISSetupPrerequisites folder “As Administrator”.

4. After you perform the procedures on the Embedded machine, run the project again and check if the error persists.